Hamilton LEDIT-B100 LED Dimmer Module – Discontinued
Hamilton LEDIT-B100 LED Dimmer Module is a programmable 5-100W dimmer designed for compatible dimmable LED lighting. This model has now been discontinued and is no longer available to purchase. This page is retained for product information, identification and technical reference.
The Hamilton LEDIT-B100 has been replaced by the newer Hamilton LEDITB100R-FLG LED Dimmer Module.
Discontinued Product
- Hamilton product code: LEDIT-B100
- This product has been discontinued
- No longer available to purchase from Electrical4Less
- Product page retained for technical and replacement reference
- Replacement model: Hamilton LEDITB100R-FLG
Programmable LED Dimming
The LEDIT-B100 was designed to provide smooth and configurable control of compatible LED lighting. It supports both trailing edge and leading edge operation, allowing the dimming mode to be selected to suit the connected lighting load.
Trailing edge operation is the default setting and is suitable for many modern dimmable LED lamps, while leading edge mode can be selected where required for compatible installations.
Key Features
- 5W minimum LED load
- 100W maximum LED load
- Suitable for up to 10 compatible LED lamps within the rated load
- One-way and two-way switching capability
- Push on/off rotary dimmer operation
- Leading edge and trailing edge dimming modes
- Programmable minimum dimming level
- Soft start operation
- Short-circuit protection
- Thermal protection against excessive operating temperature
Soft Start and Protection
Soft start operation gradually applies power to the connected lighting load rather than switching immediately to full output. This helps provide smoother operation with compatible LED lamps.
The dimmer also incorporates short-circuit and thermal protection. If excessive temperature is detected, operation is suspended until the unit returns to a safe operating temperature.
Installation Information
The Hamilton LEDIT-B100 was designed for installation in a suitable wall box, with a 35mm flush box recommended for adequate installation depth.
Always ensure the connected lamps are dimmable and compatible with the selected leading edge or trailing edge operating mode.
Replacement for Hamilton LEDIT-B100
The Hamilton LEDIT-B100 LED Dimmer Module has been superseded by the Hamilton LEDITB100R-FLG.
Customers looking to replace an existing LEDIT-B100 should check the specification and installation requirements of the newer replacement before ordering, particularly where the existing installation uses a specific Hamilton plate, adaptor, carrier or control knob.
This discontinued product page remains available to help electricians, installers and customers identify existing Hamilton LEDIT-B100 dimmers and locate the current replacement.
